Printek FormsPro 4300 User Manual download pdf (Page 63)

Optional Coaxial/Twinaxial Interface

Page C-5

Option Switches When Configured for Twinaxial Operation

The dipswitches as shown above have the following meanings when the interface is

configured for twinaxial operation. An asterisk (*) indicates the factory default setting.

Switch/Position Function

SW1-1 SW1-2 Select Emulation

OFF* OFF* 4214 Model 2.

ON OFF 5225 Model 3.

OFF ON 5256 Model 3

ON ON Reserved for future use.

SW1-3 OFF* Reserved for factory use.

SW1-4 OFF* Reserved for factory use.

SW1-5 SW1-6 Default Character Set.

OFF* OFF* Multinational.

ON OFF U.S.A.

OFF ON Austrian/German.

ON ON French Canadian.

SW1-7 SW1-8 Parallel Multiplexer Timeout.

OFF* OFF* Short (15 seconds).

ON OFF Medium.

OFF ON Long.

ON ON Very Long (60 seconds).

SW2-1 OFF* Run.

SW2-1 ON Test.

Addr 0-6 = Code Dump.

Addr 7 = Configuration Printout.

Addr 8 = Print Test.

Addr 9 = Loop Test.

SW2-2 OFF* Send 5E Hex (^) for Logical Not.

SW2-2 ON Send E1 Hex ( ) for Logical Not.

SW2-3 OFF* Load Forms Enabled.

SW2-3 ON Load Forms Disabled.

SW2-4 OFF* Reserved for future use.

Twinaxial Address Switch

The “ADDR” switch sets the logical device address. You may wish to use a small

screwdriver to turn the knob on this switch. Note that there is a black line on the side of this

knob which indicates the address that is currently selected. Only addresses 0 through 6 are

valid for twinaxial operation. Addresses 7, 8, and 9 are used for diagnostic purposes only and

are described later in this appendix in the section titled “Coaxial/Twinaxial Interface

Diagnostics”.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 104 105

No comments

Printek FormsPro 4300 User Manual Page 63