Printek FORMSMASTER 8000SE Operator's Manual download pdf (Page 33)

DAILY OPERATION

25

and the bottom line of the display will show

the path(s).

FORM FEED:

• If a form is currently loaded and perhaps

partially printed, this button will advance the

bottom of the current form to the tear bar so

that it may be torn off.

• If a form has already been advanced to the

tear bar, this button will advance the next

form to the tear bar.

FORM SELECT

/UNLOAD

This button is used to access up to ten different

forms which have been previously configured

with the Setup menus (see the chapter on Printer

Configuration for more information).

When this button is pressed, one of two functions

will be performed.

UNLOAD:

• If a form is currently in position to be

printed, this button will pull the form down

until the top of the form is below the top of

the tractors. In the FormsMaster 8003se

this will also cause the tractor shuttle to

move forward for easy access to all tractors.

FORM SELECT:

• If the form has already been pulled down to

the tractors as described above, this button

will cycle through all the available form

choices. Forms which are not considered to

be “loaded” in the tractors will flash <not

loaded> on the bottom line of the display.

In the FormsMaster 8003se the not loaded

message will alternate with the tractor path

assigned to that form. For more information,

see the following section on “Selecting and

Loading Forms

”.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 126 127

Comments to this Manuals

No comments