Printek FORMSMASTER 8000SE Operator's Manual download pdf (Page 36)

DAILY OPERATION

case of the FormsMaster 8003se this will also move the shuttle

forward for easy access to all tractor paths.

3. Continue to press the FORM SELECT button until the desired form

name is shown on the top line of the display. The form name will be

FORM 0 through FORM 9 or the actual name of the form if the

name has been set in Setup. If the desired form is not considered to

be “loaded” by the printer, <Not Loaded> will flash on the

bottom line of the display. In the case of the FormsMaster 8003se

the not loaded message will alternate with the path(s) that this form is

to be loaded in.

Loading the Form in the Tractors

4. Open the paper door on the front of the printer. This will provide

access to the tractors as shown below. If your printer is a

FormsMaster 8000se, only one set of tractors will be available and

you may skip ahead to step 6.

FormsMaster 8003se tractors

5. Depending upon which path(s) the new form is to be placed in, you

may need to tilt the front and/or center tractors forward as shown.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 126 127

No comments

Printek FORMSMASTER 8000SE Operator's Manual Page 36