Printek FORMSMASTER 8000SE Operator's Manual download pdf (Page 47)

DAILY OPERATION

Finally, place the printer back on line by pressing the ONLINE button.

This will automatically load the new form and begin printing. Depending

upon how the printer has been set up, the printer may start printing where it

left off or it may start at the beginning of the page where the error occurred

and reprint the entire page. See “Paper Out Fault Action” on page 61 for

more information.

No Paper to Load

This error occurs when the LOAD button has been pressed and there is no

paper or form in the tractors. Place paper in the tractors and press LOAD

again.

Too Much Paper to Unload

This error occurs when the UNLOAD button has been pressed and there is

paper present too far beyond the tear bar. This error serves as a warning

that you may be putting forms that have already been printed on back into

the printer. Tear off any printed forms past the tear bar and press UNLOAD

again. This error also occurs if the LOAD button has been pressed and the

current form cannot be unloaded.

Selected Form is Not Loaded

This error occurs when ONLINE has been pressed and the currently selected

form is displaying <Not Loaded>. Either press LOAD to load the

selected form or select a different form and then press ONLINE.

No Ribbon or Wrong Ribbon

This error occurs when the printer is attempting to go on line and cannot

detect the presence of a ribbon cartridge. This may be due to the ribbon

not actually being present in the printer, or the ribbon may not be installed

properly.

This error may also occur when attempting to use a non-Printek brand

ribbon. Before attempting to use a ribbon brand other than Printek, please

read “Why Use Only Printek® Brand Ribbons” on page 10. Then if you

do decide to use non-Printek brand ribbons, refer to “Ribbon Checking”

on page 64.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 126 127

No comments

Printek FORMSMASTER 8000SE Operator's Manual Page 47