Printek FormsPro 4300 User Manual download pdf (Page 21)

Page 3-1

OPERATION

INTRODUCTION

This section assumes that your printer has already been installed according to the information

in “Installation and Quick Setup”, and describes the daily operation of the FormsPro 4000

series printers. In particular, using the control panel, changing paper or forms, and changing

the ribbon cartridge are discussed.

CONTROL PANEL OPERATION AND SETUP MENUS

The FormsPro 4000 series printers feature an intuitive, easy-to-use control panel which

provides immediate access to the controls required by most operators. Individual indicators

are available which provide a quick indication of printer status, as well as a 16-character

display which provides even more status information.

Many more features, including form and interface parameters, are available through the

SETUP mode. All features which are modified during setup are stored in nonvolatile

memory and are used each time the printer is turned on or reset. For more information, refer

to the appendix on “Printer Reset Conditions”.

The printer's control panel consists of six pushbutton switches, four LED indicators, and a 16-

character LCD as shown below.

Printer Control Panel.

The pushbutton switches (or buttons), the LCD, and the LED indicators provide you with the

following controls and status information:

CONTROL PANEL DISPLAY AND INDICATORS

Sixteen Character Display This display indicates the printer status. Normally, the

currently-selected form (and tractor path on the

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 104 105

No comments

Printek FormsPro 4300 User Manual Page 21