Printek FormsPro 4300 User Manual download pdf (Page 89)

Page G-1

APPENDIX G

PRINTER RESET CONDITIONS

The following list describes conditions that are assumed whenever power is applied to the

printer, the SETUP mode is exited, or a reset escape sequence is received (when the printer is

operating in an emulation mode that supports such a sequence).

This list includes all variables that you can modify for all emulations, even though some

emulations cannot modify all of the variables shown. Refer to the appropriate section of this

manual for the emulation you are using.

Variable Reset Condition

character pitch according to current form setup

left margin according to current form setup

right margin according to current form setup

line pitch according to current form setup

form length according to current form setup

top margin according to current form setup

bottom margin according to current form setup

font according to current form setup

impact mode according to current form setup

language according to current form setup

normal/slashed zero according to current form setup

auto cut mode according to current form setup

unidirectional mode according to current form setup

top of form set to current position

text in an incomplete line discarded

input buffer cleared (unless reset from host)

control of data bit 8 accepted as received

control character symbols according to interface setup

italics off

double high off

double strike off

double wide off

emphasized off

superscript/subscript off

underline off

horizontal tabs to every eight columns

vertical tabs cleared

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 104 105

No comments

Printek FormsPro 4300 User Manual Page 89