Printek FormsPro 4300 User Manual download pdf (Page 40)

Using Special Features

Page 4-2

If you do not wish to finish printing this line/form, you may force the printer to delete this

partial line from its buffer by pressing and holding the UNLOAD/FORM SELECT button

through the following series of messages. When the printer displays “Finish Printing!”,

continue to hold the button. After two seconds the printer will display “Cancel Printing?”.

Continue to hold the button for two more seconds and the printer will display “Print

Canceled”. Now release the button and you may change the paper, or you may press the

FORM SELECT button to select another form.

HANDLING A PAPER ERROR CONDITION

Paper errors may be caused by either a paper out or a paper jam. The printer will deal with a

paper error condition in one of two ways. The factory default method is described below

under “Standard Paper Out Handling”. For a description of how paper errors are handled

when Page Reprint is enabled, refer to “Handling Paper Errors With Page Reprint Enabled”

in the “ Page Reprint” section that follows.

Standard Paper Error Handling

The standard way of dealing with a paper error is that printing will stop and the printer will

go off line as soon as a paper error condition is detected. In the case of paper out, the paper

will be ejected from the tractors. Printing will continue at the top of the next form when it is

loaded.

PAGE REPRINT

Page Reprint is a feature which may be used to reprint a page in its entirety after a paper error

occurs, rather than just resuming printing as described above. This may be used when you

are printing on preprinted forms to prevent splitting one form's data onto two separate pages.

Please read through all of the following topics concerning Page Reprint to make sure you

wish to use it before you enable it.

Enabling Page Reprint

To enable page reprint, first take the printer off-line. Press and hold the SETUP button until

“Setup: INTERFACE” is displayed. Then press the FUNCTION UP button until “Fault:” is

displayed. Now press a VALUE button to select “Reprint Pg”. You must now set the page

size as described below.

Setting the Reprint Page Size

After you select reprint page, press the FUNCTION UP button to display “Page Size:”.

Before you use the VALUE buttons to select the page size, please read the following

discussion, which describes the available values.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 104 105

No comments

Printek FormsPro 4300 User Manual Page 40